Songhe HM-10 Bluetooth 4.0 BLE iBeacon UART Module with 6PIN Base Board for Arduino (2PCS)

Description

• Make sure this fits by entering your model number.
• 1. Internal logic level conversion circuit. No need to externally convert 5V level to 3.3V level
• 2. The power input port is equipped with anti-reverse circuit. Avoid accidental power plugging, which may cause the module to burn out.
• 3. Support Apple system, Android phone
• 4. The default baud rate is 9600 8n1
• 5. Voltage 3.6 V to 6V

Advantages of this module: 1. Internal logic level conversion circuit. No need to externally convert 5V level to 3.3V level 2. The power input port is equipped with anti-reverse circuit. Avoid accidental power plugging, which may cause the module to burn out. Support Apple IOS5 /IOS6 system hm-10 tutorial: Several important points of IOS, I hope that customers before using the module (Applicable to Apple machines after 4s 5 5s) Use on IOS: 1. IOS search for Bluetooth, not search and pair Bluetooth in Settings-“Bluetooth. (Only Bluetooth headsets can be connected in IOS settings. Wireless data devices cannot be found) 2. In IOS, search for the LightBlue software in the appstore, and then open the LightBlue software to search for HM-10, and pair and test sending and receiving! Android phone 1. First confirm whether the Bluetooth module of the Android phone hardware supports Bluetooth 4.0. (If the phone hardware module does not support it, the software will not be connected if it is done correctly!) 2. Upgrade the system to version 4.3 or later 3.HMBLEComAssistant.rar can be used for testing PS: Develop the mobile terminal of IOS or Android. Please visit http://www.jnhuamao.cn/download.asp?ID=0 to download the latest source code for reference! HM-10 module configuration requires a USB to TTL device. No wireless pairing can be configured! (Because after wireless pairing, the data is directly transmitted transparently) 1. The LED flashes slowly when it is not paired and connected with the remote device. At this time, you can use AT commands to configure the module. 2. The HM-10 module can only recognize all uppercase AT commands, and does not support lowercase and mixed case. 3. The factory default baud rate is 9600 8n1 Slave settings AT+BAUD0 //9600 will take effect after power off and restart AT+NAMEAC AT+PASS000000 //You must enter full 6 digits AT+TYPE1 AT+ROLE0 Host settings: AT+BAUD0 //9600 will take effect after power off and restart AT+NAMEAC AT+PASS000000 //You